Moersch Tanol Film Developer
2 x 250 ml

  • $56.99
In Stock
Stock availability shown for online orders. For stock at our Hollywood retail store please call 323-284-4321
Mfg: Moersch

Moersch Tanol is a staining developer which yields high resolution, maximum sharpness and fine grain.

Suitable for tank and tray development.

It is also possible to use this developer in a rotation tank. However, in direct comparison the sharpness is significantly lower.

You do not need to rinse before developing the film. The only exception is Delta 400. After a couple of minutes of developing this film you get a lot of foam in the tank. If the tank is only filled to just about cover the film, this can lead to errors in development. You can overcome this problem by rinsing the film for 2 to 3 minutes before you develop.

Dilute developer and alkali with water in a ratio of 1+1+100. Do this immediately before you start developing. In such high dilutions the water quality can have consequences for the film speed. Therefore we recommend the use of distilled water. In tap water the film speed can be 1°DIN higher as well as lower than shown in the development table.

Unlike the familiar staining developers on the basis of pyrogallol, auto-oxidization of Tanol starts a lot later. This is an advantage when developing N+ based on the zone system. During long development times you don't need to worry about early exhaustion.

As with pyrogallol a dye builds up proportionally to the silver density. The "Tanol stain" is less obvious to see than the "pyro stain" but just as effective. The dye accumulates between the grains of silver and lessens the impression of graininess that necessarily occurs with all sharpness developers.

When using graded paper the stain has little influence on the highlight contrast as long as you stick with the recommended times. On VC paper the stain acts as an additional soft filter in the higher densities.

This developer is especially interesting for large format negatives. The results will be suitable for conventional development as well as alternative development techniques such as platinotype and cyanotype. When using contact printing techniques of the early days of photography, you need negatives with dense highlights and a straight lined density curve. The contrast range should be between 1.7 and 2.0 logD. When printing, expose with daylight or UV light. Since the stain blocks UV light, you can print straight from the original negative.

The stock solutions have a shelf life of 2 to 3 years (even when opened)

EAN: 4260349890229
Chemical Type BW Film Developer
You might also like